Browse Categories
Browse by Manufacturer
Mailing Lists
Search

Simpson CS16SS Coiled Strap 16gauge 150FT Roll Stainless Steel


MSRP: $929.99
Price: $775.72
You Save: $154.27 (17 %)
Item Number: CS16SS
Manufacturer: Simpson Strong-tie
Manufacturer Part No: CS16SS
Simpson CS16SS Coiled Strap 16gauge 150FT Roll Stainless Steel
These products are available with additional corrosion protection. Additional products on this page may also be available with this option, check with Simpson Strong-Tie for details.
Table
    1. Loads include a 60% load duration increase on the fasteners for wind or seismic loading.
    2. Use half of the required nails in each member being connected to achieve the listed loads.
Allowable Load =      No. of Nails Used  
No. of Nails in Table
 x Table Load
 
Allowable Load =   40 Nails (Used) 
50 Nails (Table)
 x 4585 lbs = 3668 lbs
  1. Calculate the connector value for a reduced number of nails as follows:

    Example: CMSTC16 in DF/SP with 40 nails total.
    (Half of the nails in each member being connected)

  2. Tension loads apply for uplift when installed vertically.
  3. NAILS: 16d = 0.162" dia. x 3 1/2" long, 16d Sinker = 0.148" dia. x 3 1/4" long, 10d = 0.148" dia. x 3 " long. See other nail sizes and information.

CMSTC provides nail slots for easy installation; it can be cut to length. CS are continuous utility straps which can be cut to length on the job site. Packaged in lightweight (about 40 pounds) cartons.

Finish: Galvanized. Some products available in ZMAX coating; see Corrosion Information.

Installation:

  • Use all specified fasteners. See General Notes.
  • Wood shrinkage after strap installation across horizontal wood members may cause strap to buckle outward.
  • Refer to the applicable code for minimum nail penetration and minimum wood edge and end distances.
  • The table shows the maximum allowable loads and the nails required to obtain them. Fewer nails may be used; reduce the allowable load as shown in footnote 3.
  • The cut length of the strap shall be equal to twice the "End Length" noted in the table plus the clear span dimension.
  • CMST only - Use every other triangle hole if the wood tends to split. Use round and triangle holes for comparable MST loads, providing wood does not tend to split.
  • For lap splice and alternate nailing information, See Technical Bulletin T-CMST.
  • CS straps are available in 25' lengths, order CS14-R, CS16-R, CS18-R, CS20-R or CS22-R.
Gauge stamped on part for easy identification

Product Reviews

Rate This Product:
or Create a Review
(0 Ratings, 0 Reviews)