Browse Categories
Browse by Manufacturer
Mailing Lists
Search

Simpson ET56 Epoxy 56oz Double Tube


MSRP: $72.99
Price: $59.13
You Save: $13.86 (19 %)
Item Number: ET56
Manufacturer: Simpson Strong-tie
Manufacturer Part No: ET56
Simpson Strong-Tie ET56 Epoxy 56oz
ET22 is a two-component, high solids, epoxy-based system for use as a high-strength, non-shrink anchor grouting material. Resin and hardener are dispensed and mixed simultaneously through the mixing nozzle.

Surfaces to receive epoxy must be clean. For installations in or through standing water, see Supplemental Topics for Adhesive Anchors for details. The base material temperature must be 40°F or above at the time of installation. For best results, material should be 70°F - 80°F at the time of application. Cartridges should not be immersed in water to facilitate warming. To warm cold material, the cartridges should be stored in a warm, uniformly heated area or storage container for a sufficient time to allow epoxy to warm completely. Mixed material in nozzle can harden in 5–7 minutes at a temperature of 40°F or above.

Tension Loads for Threaded Rod Anchors in Normal-Weight

Concrete Stemwall

 
Tension Load Threaded Rod Normal Weight Concrete
  1. Allowable load must be the lesser of the bond or steel strength.
  2. The allowable loads listed under allowable bond are based on a safety factor of 4.0.
  3. Refer to in-service temperature sensitivity chart for allowable load adjustment for temperature.
  4. Anchors are permitted to be used within fire-resistive construction, provided the anchors resist wind or seismic loads only. For use in fire-resistive construction, the anchors can also be permitted to be used to resist gravity loads, provided special consideration has been given to fire-exposure conditions.
Edge and end distances for threaded rod in concrete foundation stemwall corner installation

Product Reviews

Rate This Product:
or Create a Review
(0 Ratings, 0 Reviews)