Browse Categories
Browse by Manufacturer
Mailing Lists

Simpson TTN25234PFSS Titen Tapcon 1/4 x 2-3/4" PFH Stainless Steel -100ct

MSRP: $59.99
Price: $51.04
You Save: $8.95 (15 %)
Item Number: TTN25234PFSS
Manufacturer: Simpson Strong-tie
Manufacturer Part No: TTN25234PFSS
Simpson TTN25234PFSS Titen Tapcon 1/4 x 2-3/4" PFH Stainless Steel -100ct

The stainless-steel Titen screws attach various types of components to concrete and masonry in 
environments where a medium level of corrosion resistance is required. Available in hex and phillips head, the Titen screws are designed for use with appropriatelysized drill bits that are included with each box.

• Type 410 grade stainless steel zinc plated with a protective top coat for added corrosion protection
• Suitable for concrete, brick, grout-filled CMU and hollow-block applications
• Suitable for some preservative-treated wood applications
• Available in lengths from 1 1⁄4" to 4"
• 5% observed red rust after 1500 hours of ASTM B117 salt spray test*

* Salt-spray test performance is based on tests on uninstalled fasteners,  and may not reflect actual performance when installed. This information is provided for comparative purposes only.

MATERIAL: Heat-treated type 410 stainless steel

FINISH: Zinc plated with a protective top coat

Caution: Industry studies show that hardened fasteners can experience performance problems in wet or corrosive environments. Steps must be taken to prevent inadvertent sustained loads above the listed allowable loads. Overtightening and bending moments can initiate cracks detrimental to the hardened screw's performance. Use the Simpson Strong-Tie Titen installation tool kit as it has a bit that is designed to reduce the potential for overtightening the screw.

Caution: Oversized holes in the base material will reduce or eliminate the mechanical interlock of the threads with the base material and will reduce the anchor's load capacity.

• Drill a hole in the base material using the appropriate diameter carbide drill bit as specified
in the table. Drill the hole to the specified embedment depth plus
1⁄2" to allow the thread
tapping dust to settle and blow it clean using compressed air. Overhead installations need
not be blown clean. Alternatively, drill the hole deep enough to accommodate embedment
depth and dust from drilling and tapping.
• Position fixture, insert screw and tighten using drill and Titen screw installation tool fitted
with a hex socket or phillips bit.
For contact with preservative-treated wood and untreated wood, reference the table on page 12.
Use caution not to damage coating during installation. The type 410 stainless-steel Titen with
a protective top coat provides "medium" corrosion protection. Recommendations are based on
testing and experience at time of publication and may change. Simpson Strong-Tie cannot provide
estimates on service life of screws. Contact Simpson Strong-Tie for additional information.

Product Reviews

Rate This Product:
or Create a Review
(0 Ratings, 0 Reviews)